8 EasyLine EL3060 Series Commissioning Instructions
Instructions and Regulations to be observed
These include
· The contents of this operator's manual,
· The safety information affixed to the device,
· The applicable safety regulations for installing and operating electrical
devices,
· The applicable safety regulations for working with gases, acids,
condensates, etc.
National Regulations
The regulations and norms, standards and directives cited in this
operator's manual are applicable in the Federal Republic of Germany.
The applicable national regulations should be followed when the device is
used in other countries.
Device Safety and Safe Operation
The device has been designed and tested in accordance with EN 61010
Part 1, "Safety requirements for electrical equipment for measurement,
control, and laboratory use" and has been shipped ready for safe
operation.
In order to maintain this condition and to assure safe operation, safety
information in this manual must be observed. Failure to do so can put
persons at risk and can lead to device damage as well as damage to
other systems and devices.
Comply with the safety regulations
The safety regulations for explosion protection must be complied with
without fail before carrying out any work on the instrument.
Carrying out work with an explosion hazard is prohibited
Carrying out work on live parts, with the exception of intrinsically safe
circuits, and with auxiliary equipment which represents a danger of
ignition is prohibited if there is an explosion hazard.
Equipotential bonding connection
The local potential equalization must be connected before any other
connections are made.
Risks of a Disconnected Protective Lead
The device can be hazardous if the protective lead is interrupted inside or
outside the device or if the protective lead is disconnected. Carrying out
work on the potential equalization or the equipotential bonding connection
is prohibited if there is an explosion hazard.
To Next Page
Loading...
Need help?
General
