4 Repair
4.7.1. Replacement gearbox axis 1
3493HAC026876-001 Revision: C
© Copyright 2006-2008 ABB. All rights reserved.
2. Make sure the o-ring is fitted to the gearbox
as shown in the figure to the right.
Lightly lubricate the o-ring with grease.
Art. no. is specified in Required
equipment on page 345.
xx0200000055
• A : O-ring (Gearbox shown from
the side)
3. Refit the cable guide in the center of
gearbox 1 with its attachment screws.
Shown in the figure Location of gearbox
axis 1 on page 345.
4. Fit two lifting eyes on each side of the
gearbox and secure it with a roundsling.
Art. no. is specified in Required
equipment on page 345.
5. Fit two guide pins in two of the attachment
holes, parallel to each other.
6.
CAUTION!
The gearbox weighs 108 kg! All lifting
equipment used must be sized accordingly!
7. Lift the gearbox on to the guide pins and
lower it carefully to its mounting position.
Action Note
Continued
Continues on next page
To Next Page
Loading...
