6.2 General installation instructions
• Terminate all branches of the wiring system via a connected bus device (e.g.,
indoor station, outdoor station, system device).
• Do not install the system controller directly next to the bell transformer and other
power supplies (to avoid interference).
• Do not install the wires of the system bus together with 100-240 V wires.
• Do not use common cables for the connecting wires of the door openers and wires
of the system bus.
• Avoid bridges between different cable types.
• Use only two wires for the system bus in a four-core or multi-core cable.
• When looping, never install the incoming and outgoing bus inside the same cable.
• Never install the internal and external bus inside the same cable.
Pos: 83 /Busc h-Jaeger (Ne ustruktur)/Modul- Struktur/Onlin e-Dokumentati on/Steuermodul e - Online-D okumentation (--> F ür all e Dokument e <--)/+++++++ +++++ Seitenumbruch +++ +++++++ ++ @ 9\mod _126889866809 3_0.docx @ 5 2149 @ @ 1
To Next Page
Loading...
