EasyManua.ls Logo

ABB MagMaster - SPECIFICATION; Sensor Specification - Flow Range

ABB MagMaster
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
Requires Level 2 access>
Input
Input Anlg
Input Clr
Input Hld
Input Zero
Input Idle
Input Quit
9
1 > 0
2 > 1
3 > 0
4 > 0
5 > 0
Q >
9 >
Mtsnsr
Mtsnsr Trip
Mtsnsr mv
Mtsnsr Quit
A
1 >
2 >
Q
Q
A >
Snsr
Snsr No
Snsr Tag
Snsr Size
Snsr Vel
Snsr Fact
Snsr Quit
B
1 >
2 >
3 >
4 >
5 >
Q
B >
Main Menu Sub-menus Remarks
5
Snsr Fact
Snsr Fact
Snsr Fact
Snsr Fact
Snsr Quit
1 >
2 >
3 >
4 >
Q
#
Active level on contact input selects Analogue Range 2
Active level on contact input will reset totaliser.
Active level on contact input will hold owmeter output value.
Active level on contact input will set owrate output to zero.
Enter inactive state of input contact (1 for Hi normal: 0 for Lo normal).
Enter Q (CR) to return to Main Menu or (CR) to cycle around this menu.
Set up empty pipe detection.
Set empty pipe detector trip threshold.
Actual measured value related to uid conductivity.
Enter Q (CR) to return to Main Menu or (CR) to cycle around this menu.
Sensor calibration details etc.
Descriptor (up to 13 characters).
Sensor calibrated bore, in millimetres.
Displays the current velocity in the sensor.
Sensor calibration data -
should agree with sensor data labee
Enter Q (CR) to return to Main Menu or (CR) to cycle around this menu.
Set up function of external logic input
(EXT I/P+, EXT I/P- terminals on transmitter cable termination BLK2).
…B1.2 Description of Parameters
Information. The following parameters require Level 2 access. Enter password in
Login En parameter above (31 from Main Menu).
APPENDIX B…

Other manuals for ABB MagMaster

Related product manuals