15 | © 2022 ABB | - 1SDH002203A1002
ABB | E-kit
Ethernet communication interface (ports ETH1 and ETH2)
Setting of static IP address with DHCP
Power-up E-kit and press button CFG to access the configuration
Press the arrow key to select the port (Eth1 or Eth2)
Press CFG to set the mode with static address
Press the arrow key to select the DHCP setting
The word DHCP will start to flash. Press CFG to confirm the setting.
Press OK to confirm the changes
The changes will be implemented once OK has been pressed for
the second time. Shut down the CPU and then reboot to make the
changes effective
Configuration of
PC Ethernet network
To access E-kit via a PC, this latter must have a compatible network address. If the E-kit address is
192.168.0.113, then the PC can be assigned address 192.168.0.114.
The procedure for configuring the IP address of a PC with Windows 10 Operating System is given below.
1. Right-click on the Start icon at the bottom left and select Settings.
2. Having accessed the Settings window, click on Network & Internet.
To Next Page
Loading...
