ABB | E-kit
20 | © 2022 ABB | - 1SDH002203A1002 Web interface configuration
3. Click on Backup to SD to make a backup of the configuration on an SD card. Otherwise click on
Close.
Note: “No SD card” will appear if the SD card has not been inserted or has not been inserted properly.
Copy configuration
to another E-kit
You can copy the configuration of an E-kit into another E-kit using the SD card.
1. Save the configuration of the first E-kit in the SD card ( > Save > Backup to SD).
2. Remove the SD from the first E-kit.
3. Insert the SD into the other E-kit and click on to reboot it. A window will appear asking for
confirmation before rebooting. Click on OK.
Configuration of a device
Individual devices can be configured in the Admin user mode. Click on the icon at the top of the menu to
access the required section. The first ten devices are displayed. Use arrows < and > to browse through the
pages of the up to 45 available devices.
Each device comprises the following parts, indicated in the figure below:
1. Index of device, i.e. the order in which the devices were inserted;
2. Name of device;
3. Template of device;
4. Communication status (red: not connected, green: connected, white: not used);
To Next Page
Loading...
