17 | © 2022 ABB | - 1SDH002203A1002
ABB | E-kit
Commissioning of E-kit
6. Make sure that the Use the following IP address item has been selected and fill out the parameters
as follows:
• IP address: 192.168.0.114
• Subnet mask: 255.255.255.0
• Default Gateway: gateway address, if present.
6 - Commissioning of E-kit
Power-up
E-kit powers up automatically when correctly supplied. After power-up, the word E-Kit will appear on the
display.
From this moment onwards, all the information acquired by the devices will be accessible via Modbus RTU
and TCP.
Firmware upgrade
New firmware can be obtained if the following situation occurs:
• Faulty operation of web interface
Send an email to the Support Center (global-el.operations.digital@abb.com). The Support Center will provide
help and guide you through the E-kit firmware upgrade.
To Next Page
Loading...
