ABB PQstorI - 9.3 Programming

33
PQSTORI INSTRUCTION MANUAL
Apply voltage to the module
(a)
Apply voltage to the module (restore upstream protection)
Connect to Wi-Fi user interface, start the module, status button turns red
Fans start running
Program equipment
(b)
Network characteristics
- Supply voltage (V)
- Supply frequency (Hz)
- Synchro mode (should normally not be changed, default value is Single ph.)
Ratings
- 
CT position and ratio
- Automatic detection feature used YES/ NO
- 
(a)

- 
(a)

- 
(a)

- 
- 
- 

- 
9.3 Programming
Remarks:
(a)

(b)
Consult the manual provided with the HMI installation kit (sold separately).
Project:
PQstorI Issued by:
Commissioning report Date: 