USER INTERFACE | INSTALLATION 19
—
Table 13: Ambient conditions for operation and storage
Name Storage Operation
Altitude
Temperature
(a)
Relative humidity
(b)
(c)
—
04 Installation
4.1 Upon reception
Before installing the PQstorI make sure that:
The packaging used for delivery is in
good condition
There are no signs of transportation damage
Your package also contains a communication
cable to operate modules in parallel
Notify any loss or damage to these items
immediately to your ABB representative.
4.2 Location
Make sure that you transport, store and operate
the product within the range of temperature,
(a)
Up to 50°C (122°F) with auto-derating
(b)
Locations with normal levels of contaminants, experienced in urban areas with scattered industrial
activity or heavy traffic.
(c)
Locations with no special precautions taken to minimize the presence of sand or dust.
The product weighs approximately 20 kilograms and can be lifted by hand by two people. It must be
installed indoors under IP20 standard protection class when fitted in cabinets. Its operation emits
below 61 dBA of noise at one meter of the module.
humidity and environmental contaminants set
out in Table 13. Install the module in a location
free of conductive dust that may damage the
equipment.
4.3 Identification tag
Each PQstorI is fitted with identification
nameplates on its front panel detailing the
product model, nominal voltage range, network
frequency, serial number and ABB internal article
code.
To Next Page
Loading...
