- 48 -
000407BG
5 - Installation
Connect all the strings required by the system, always checking the seal
of the connectors.
The gure below shows a connection example of the string inputs on a
PVI-3.0-TL-OUTD-S inverter. The “IN1” input channel is connected to a
string, while the protective covers are installed to unused connectors.
If any string inputs are not required, you must ensure that covers are installed to the connec-
tors, and install any which are missing.
This is necessary both for the inverter seal, and to avoid damage to the free connector which
may be used at a later time.
IP65
Скачано с сайта интернет магазина https://axiomplus.com.ua/
To Next Page
Loading...
