21
4.1.7. SPA password
The password for SPA bus communication is required for altering parameter values
via the SPA bus. The default password is 001. You can change the SPA password
either via the HMI or the SPA bus by first entering the currently valid password into
parameter V160 and then entering the new password into parameter V161.
Change the SPA password as follows:
1. Press an arrow button to access the main menu
2. Use the arrow buttons to select CONFIGURATION\COMMUNICATION\SPA
SETTINGS\PASSWORD SPA and press
.
3. Press
to enter the setting mode and give the current HMI password if
required. If the default password 999 is still valid, no password is required.
4. The first digit of the password to be edited starts to flash. Set the digit using
and .
5. Activate the next digit to be set by pressing
or .
6. To store the new SPA password and return the display to the view mode, press
. The display confirms the storage by flashing "---" once on the display.
Alternatively, to exit the setting mode without storing the SPA password change,
press
once before confirming and the display returns to the view mode.
7. Press
to return the display to the idle mode.
HMI PASSWORDS
TIME
LINE-IDLE STATE
CONNECTION TYPE
TRIP CIRCUIT SUP
Main Menu
Group Menu
Parameter Menus
SETTINGS
CONFIGURATION
MEASUREMENTS
RECORDED DATA
COUNTER :xxx
UNIT ADDRESS :xxx
MODBUS SETTINGS
SPA SETTINGS
REAR PROTOCOL
FREQUENCY
CONFIGURATION
FUNCTION TEST/DI
COMMUNICATION
LANGUAGE
REAR CONNECTION
CONFIGURATION
MEMORY SETTINGS
IEC103 SETTINGS
PASSWORD SPA :xxx
CONFIGURATION
RTD INPUTS
REAR COM. MODULE
Confirm
Cancel
Scroll for the digit
Set the digit
INFO
STORE COUNTER
A040233_2
Fig. 4.1.7.-1 Changing SPA password
4.1.8. How to select language
The relay allows you to choose among several different languages. The default
language is English.
Change the display language as follows:
Motor Protection Relay
Operator's Manual - ANSI ve rsion
REM 610REM 610
1MRS755538
To Next Page
Loading...
Need help?
General
