26. Accessories and ordering data
Table 102. Pilot wire communication
Item Order number
Pilot Wire communication package including two Pilot Wire modems: RPW600AM (master) and RPW600AF
(follower)
RPW600AMF
Diagnostics kit including the RPW-diagnostic tool, a diagnostic cable and a CD with necessary drivers and
information
RPW600ADP
3.0 meter LC-LC single-mode fiber optic patch cable for connecting one Pilot Wire modem to the RED615 relay
1)
1MRS120547-3
1) Please note that two patch cables are required for connecting the Pilot Wire communication package (RPW600AMF).
Table 103. Mounting accessories
Item
Order number
Semi-flush mounting kit 1MRS050696
Wall mounting kit 1MRS050697
Inclined semi-flush mounting kit 1MRS050831
19” rack mounting kit with cut-out for one relay 1MRS050694
19” rack mounting kit with cut-out for two relays 1MRS050695
Mounting bracket for one relay with test switch RTXP in 4U Combiflex (RHGT 19” variant C) 2RCA022642P0001
Mounting bracket for one relay in 4U Combiflex (RHGT 19” variant C) 2RCA022643P0001
19” rack mounting kit for one relay and one RTXP18 test switch (the test switch is not included in the delivery) 2RCA021952A0003
19” rack mounting kit for one relay and one RTXP24 test switch (the test switch is not included in the delivery) 2RCA022561A0003
Replacement kit for a Strömberg SP_J40 series relay (cut-out in the center of the installation plate) 2RCA027871A0001
Replacement kit for a Strömberg SP_J40 series relay (cut-out on the left or the right of the installation plate) 2RCA027874A0001
Replacement kit for two Strömberg SP_J3 series relays 2RCA027880A0001
19” rack replacement kit for Strömberg SP_J3/J6 series relays (one cut-out) 2RCA027894A0001
19” rack replacement kit for Strömberg SP_J3/J6 series relays (two cut-outs) 2RCA027897A0001
Replacement kit for a Strömberg SP_J6 series relay 2RCA027881A0001
Replacement kit for three BBC S_ series relays 2RCA027882A0001
Replacement kit for a SPA 300 series relay 2RCA027885A0001
27. Tools
The protection relay is delivered as a pre-configured unit. The
default parameter setting values can be changed from the front-
panel user interface, the Web browser-based user interface
(Web HMI) or the PCM600 tool in combination with the relay-
specific connectivity package.
The Protection and Control IED Manager PCM600 offers
extensive relay configuration functions such as relay signal
configuration, application configuration, graphical display
configuration including single line diagram configuration, and
IEC 61850 communication configuration including horizontal
GOOSE communication.
When the Web browser-based user interface is used, the
protection relay can be accessed either locally or remotely
using a Web browser (Internet Explorer). For security reasons,
the Web browser-based user interface is disabled by default
but it can be enabled via the front-panel user interface. The
Web HMI functionality can be limited to read-only access.
The relay connectivity package is a collection of software and
specific relay information, which enable system products and
tools to connect and interact with the protection relay. The
connectivity packages reduce the risk of errors in system
integration, minimizing device configuration and setup times.
Further, the connectivity packages for protection relays of this
product series include a flexible update tool for adding one
To Next Page
Loading...
