ABB RED670 - Page 137

137 pages

To Previous Page

To Previous Page

Loading...

Contact us

ABB AB

Substation Automation Products

SE-721 59 Västerås, Sweden

Phone +46 (0) 21 32 50 00

Fax +46 (0) 21 14 69 18

www.abb.com/substationautomation

1MRK 505 346-BEN - © Copyright 2015 ABB. All rights reserved.

Table of Contents

Table of Contents2
Application3
- Description of Configuration A315
- Description of Configuration A326
- Description of Configuration B317
- Description of Configuration B328
- Main Protection Functions9
Available Functions9
Differential Protection10
Impedance Protection10
Back-Up Protection Functions12
Current Protection12
Voltage Protection12
Frequency Protection12
Multipurpose Protection13
Control and Monitoring Functions14
Secondary System Supervision14
- Total Number of Instances for Basic Configurable Logic Blocks17
- Total Number of Instances for Configurable Logic Blocks Q/T17
- Total Number of Instances for Extended Logic Package17
- Communication18
Scheme Communication19
- Basic IED Functions20
- Differential Protection21
- 1Ph High Impedance Differential Protection HZPDIF21
- Restricted Earth-Fault Protection, Low Impedance REFPDIF21
- Local HMI Functions21
- Line Differential Protection, 3 or 6 CT Sets L3CPDIF, L6CPDIF22
- Line Differential Protection 3/6 CT Sets, W/ In-Zone Transformers23
- Analog Signal Transfer for Line Differential Protection23
- Five Terminal Lines with Master-Master System23
- Distance Measuring Zone, Quadrilateral Characteristic24
- Additional Security Logic for Differential Protection LDRGFC24
- Impedance Protection24
- Full-Scheme Distance Measuring, Mho Characteristic ZMHPDIS26
- Full-Scheme Distance Protection, Quadrilateral for Earth Faults26
- Directional Impedance Element for Mho Characteristic ZDMRDIR27
- Mho Impedance Supervision Logic ZSMGAPC27
- Faulty Phase Identification with Load Encroachment FMPSPDIS27
- Phase Selection, Quadrilateral Characteristic with Settable Angle27
- High Speed Distance Protection, Quadrilateral and Mho ZMFPDIS28
- Power Swing Detection ZMRPSB28
- Power Swing Logic PSLPSCH28
- Pole Slip Protection PSPPPAM28
- Current Protection29
- Out-Of-Step Protection OOSPPAM29
- Four-Step Phase Overcurrent Protection OC4PTOC29
- Instantaneous Phase Overcurrent Protection PHPIOC29
- Stub Protection STBPTOC30
- Thermal Overload Protection, One Time Constant LCPTTR/LFPTTR30
- Breaker Failure Protection CCRBRF30
- Four Step Negative Sequence Overcurrent Protection NS4PTOC30
- Voltage Protection31
- Pole Discordance Protection CCPDSC31
- Broken Conductor Check BRCPTOC31
- Voltage Differential Protection VDCPTOV31
- Frequency Protection32
- Multipurpose Protection32
- Radial Feeder Protection PAPGAPC32
- General Current and Voltage Protection CVGAPC32
- Secondary System Supervision33
- Control33
- Fuse Failure Supervision VDSPVC33
- Synchrocheck, Energizing Check, and Synchronizing SESRSYN33
- Circuit Switch SXSWI / Reservation Function QCRSV34
- Interlocking34
- Apparatus Control APC34
- Autorecloser SMBRREC34
- Scheme Communication35
- Selector Mini Switch VSGAPC35
- Single Point Generic Control 8 Signals SPC8GAPC35
- Single Command, 16 Signals35
- Local Acceleration Logic ZCLCPSCH36
- Scheme Communication Logic for Residual Overcurrent Protection ECPSCH36
- Direct Transfer Trip DTT36
- Low Active Power and Power Factor Protection LAPPGAPC36
- Carrier Receive Logic LCCRPTRC37
- Tripping Logic SMPPTRC37
- Trip Matrix Logic TMAGAPC37
Logic37
- Group Indication Logic Function INDCALH38
- Group Warning Logic Function WRNCALH38
- Extension Logic Package38
- Basic Configurable Logic Blocks38
- Supervision of Ma Input Signals39
- Disturbance Report DRPRDRE39
- Integer to Boolean 16 Conversion IB1639
Monitoring39
- Event List DRPRDRE40
- Indications DRPRDRE40
- Event Recorder DRPRDRE40
- Event Function40
- Gas Medium Supervision SSIMG41
- Liquid Medium Supervision SSIML41
- Running Hour-Meter (TEILGAPC)41
Metering41
- Communication Protocols42
- Local HMI42
Human Machine Interface42
Basic IED Functions42
Station Communication42
- Analog and Binary Signal Transfer to Remote End43
- Static Binary Output Module SOM43
Remote Communication43
Hardware Description43
- Layout and Dimensions44
- Line Data Communication Module LDCM44
- Galvanic RS485 Serial Communication Module44
- High Impedance Resistor Unit44
- Mounting Alternatives45
Connection Diagrams46
Technical Data47
- OEM - Optical Ethernet Module48
- PSM - Power Supply Module48
- MIM - Ma Input Module48
- Auxiliary DC Voltage48
- Binary Inputs and Outputs49
- BIM - Binary Input Module49
- BIM - Binary Input Module with Enhanced Pulse Counting Capabilities49
- IOM - Binary Input/Output Module50
- IOM - Binary Input/Output Module Contact Data50
- IOM with MOV and IOM 220/250 V, 110Ma - Contact Data51
- SOM - Static Output Module: Static Binary Outputs51
- Temperature and Humidity Influence52
- Influencing Factors52
- BOM - Binary Output Module Contact Data52
- SOM - Static Output Module Data: Electromechanical Relay Outputs52
- Aux DC Supply Voltage Influence on Functionality During Operation53
- Frequency Influence53
- Type Tests According to Standards54
- Environmental Tests55
- CE Compliance55
- Line Differential Protection L3CPDIF, L6CPDIF, LT3CPDIF, LT6CPDIF57
- Distance Measuring Zone, Quad ZMQPDIS59
- Quadrilateral Characteristic for Series Compensated Lines60
- Phase Selection, Quadrilateral Characteristic with Fixed Angle60
- Full-Scheme Distance Protection, Mho Characteristic61
- Quadrilateral Characteristic, Separate Settings62
- Phase Selection with Load Encroachment, Quadrilateral Characteristic63
- High Speed Distance Protection ZMFPDIS, ZMFCPDIS63
- Distance Zones Quad W/ High Speed Distance64
- Phase Preference Logic PPLPHIZ66
- Automatic Switch Onto Fault Logic ZCVPSOF66
- Instantaneous Residual Overcurrent Protection EFPIOC68
- Four Step Residual Overcurrent Protection EF4PTOC Technical Data69
- Directional Underpower Protection GUPPDUP73
- Directional Overpower Protection GOPPDOP73
- Two Step Undervoltage Protection UV2PTUV75
- Two Step Overvoltage Protection OV2PTOV76
- Overexcitation Protection OEXPVPH76
- Loss of Voltage Check LOVPTUV77
- Underfrequency Protection SAPTUF78
- Overfrequency Protection SAPTOF78
- Rate-Of-Change Frequency Protection SAPFRC79
- Voltage-Restrained Time Overcurrent Protection VRPVOC83
- Current Circuit Supervision CCSSPVC84
- Fuse Failure Supervision FUFSPVC84
- Synchronizing, Synchrocheck and Energizing Check SESRSYN86
- Scheme Communication Logic for Distance or Overcurrent Protection88
- Phase Segregated Scheme Communication Logic for Distance Protection88
- Scheme Communication Logic for Residual Overcurrent Protection89
- Direct Transfer Trip90
- Compensated Over- and Undervoltage Protection COUVGAPC90
- Sudden Change in Current Variation SCCVPTOC90
- Negative Sequence Overvoltage Protection LCNSPTOV91
- Zero Sequence Overvoltage Protection LCZSPTOV91
- Negative Sequence Overcurrent Protection LCNSPTOC92
- Zero Sequence Overcurrent Protection LCZSPTOC92
- Three Phase Overcurrent LCP3PTOC93
- Three Phase Undercurrent LCP3PTUC93
- Tripping Logic Common 3-Phase Output SMPPTRC94
- Number of SMPPTRC Instances94
- Number of TMAGAPC Instances94
- Number of and Instances / Number of GATE Instances94
- Number of INV Instances / Number of LLD Instances95
- Number of or Instances / Number of PULSETIMER Instances95
- Number of RSMEMORY Instances / Number of SRMEMORY Instances95
- Number of TIMERSET Instances / Number of XOR Instances95
- Number of INDCOMBSPQT Instances / Number of INDEXTSPQT Instances96
- Number of INVALIDQT Instances / Number of INVERTERQT Instances96
- Number of ORQT Instances / Number of PULSETIMERQT Instances96
- Number of RSMEMORYQT Instances96
- Number of B16I Instances / Number of BTIGAPC Instances97
- Number of XORQT Instances97
- Number of Instances in the Extension Logic Package97
- Number of SRMEMORYQT Instances / Number of TIMERSETQT Instances97
- Number of IB16 Instances / Number of ITBGAPC Instances98
- Elapsed Time Integrator W/ Limit Transgression/Overflow Supervision98
- Number of TEIGAPC Instances98
- Running Hour-Meter TEILGAPC98
- Measurements CVMMXN99
- Phase Current Measurement CMMXU99
- Phase-Phase Voltage Measurement VMMXU99
- Phase-Neutral Voltage Measurement VNMMXU100
- Current Sequence Component Measurement CMSQI100
- Voltage Sequence Measurement VMSQI100
- Supervision of Ma Input Signals / Limit Counter L4UFCNT100
- Insulation Gas Monitoring Function SSIMG101
- Event List102
- Fault Locator LMBRFLO102
- Breaker Monitoring SSCBR102
- Insulation Liquid Monitoring Function SSIML102
- Indications103
- Event Recorder103
- Trip Value Recorder103
- Disturbance Recorder / Limit Counter L4UFCNT103
- Pulse-Counter Logic PCFCNT104
- Energy Metering ETPMMTR104
- IEC 61850-9-2 Communication Protocol105
- LON Communication Protocol105
- SPA Communication Protocol105
- IEC 60870-5-103 Communication Protocol / SLM – LON Port105
- SLM – SPA/IEC 60870-5-103/DNP3 Port106
- Galvanic X.21 Line Data Communication Module (X.21-LDCM)106
- Galvanic RS485 Communication Module106
- IEC 62439-3 Edition 1 and Edition 2 Parallel Redundancy Protocol106
- Line Data Communication Module107
- Hardware108
- Electrical Safety108
- Connection Safety108
- Case108
- Self Supervision with Internal Event List109
- Time Synchronization, Time Tagging109
- GPS Time Synchronization Module (GTM)109
- GPS – Antenna and Cable109
- Irig-B110
- ANSI Inverse Time Characteristics111
- IEC Inverse Time Characteristics112
- RI and RD Type Inverse Time Characteristics112
- Inverse Time Characteristics for Overvoltage Protection113
- Inverse Time Characteristics for Undervoltage Protection114
- Inverse Time Characteristics for Residual Overvoltage Protection115
- Product Definition Ordering Codes116
- Example Ordering Code116
Ordering for Customized IED116
- Differential Functions117
- Impedance Functions, Alternatives118
- Current Functions119
- Voltage Functions119
- Frequency Functions119
- General Calculation Functions120
- Secondary System Supervision Functions120
- Control Functions120
- Scheme Communication Functions120
- Logic Functions121
- Monitoring Functions121
- Station Communication Functions121
- Language Selection / Casing Selection121
- Human Machine Interface Selection122
- Connection Type for Input/Output Modules122
- Connection Type for Power Supply Module122
- Mounting Selection122
- Analog System Selection123
- Maximum Quantity of I/O Modules123
- Binary Input/Output Module Selection124
- Binary Input/Output Module Selection, Continued125
- Remote End Serial Communication Selection125
- Serial Communication Unit for Station Communication Selection125
Ordering for Pre-Configured IED126
- GPS Antenna and Mounting Details132
- Interface Converter (for Remote End Data Communication)132
- Test Switch132
Ordering for Accessories132
- External Resistor Unit133
- Combiflex133
- Configuration and Monitoring Tools133

Other manuals for ABB RED670

Commissioning Manual308 pages

Related product manuals

Preview: ABB RED615

Preview: ABB RED650

Preview: ABB REF615

Preview: ABB REG670

Preview: ABB REL670

Preview: ABB REX640

Preview: ABB RET670

Preview: ABB REB670

Preview: ABB RET615

Preview: ABB REL650

Preview: ABB ret650