ABB REF611 - Page 57

SELGAPC1
ISWGAPC1
Blocking 1
ISWGAPC5
Basic Angle
Control
DEFLPDEF1_RCA_CTL
DEFLPDEF2_RCA_CTL
DEFHPDEF1_RCA_CTL
1） Optional binary inputs
PHLPTOC1_BLOCK
PHHPTOC1_BLOCK
PHHPTOC2_BLOCK
PHIPTOC1_BLOCK
EFHPTOC1_BLOCK
DEFLPDEF1_BLOCK
DEFLPDEF2_BLOCK
DEFHPDEF1_BLOCK
ROVPTOV1_BLOCK
ROVPTOV2_BLOCK
ROVPTOV3_BLOCK
INTRPTEF1_BLOCK
NSPTOC1_BLOCK
NSPTOC2_BLOCK
PDNSPTOC1_BLOCK
T1PTTR1_BLOCK
CBPSOF1_BLOCK
X120-BI1
X120-BI2
X120-BI3
X130-BI1
X130-BI2
X130-BI3
X130-BI4
X130-BI5
X130-BI6
1）
ISWGAPC2
Blocking 2
PHLPTOC1_BLOCK
PHHPTOC1_BLOCK
PHHPTOC2_BLOCK
PHIPTOC1_BLOCK
EFHPTOC1_BLOCK
DEFLPDEF1_BLOCK
DEFLPDEF2_BLOCK
DEFHPDEF1_BLOCK
ROVPTOV1_BLOCK
ROVPTOV2_BLOCK
ROVPTOV3_BLOCK
INTRPTEF1_BLOCK
NSPTOC1_BLOCK
NSPTOC2_BLOCK
PDNSPTOC1_BLOCK
T1PTTR1_BLOCK
CBPSOF1_BLOCK
GUID-B37E732A-4522-4B96-BA67-A7C7020B40D5 V2 EN
Figure 28: Binary inputs
SELGAPC1
SELGAPC1 has inputs from protection relay binary inputs. IN_1...IN_3 are binary
inputs from X120. IN_4...IN_9 can be used while X130 optional card is taken into
use. An always true signal is connected to IN_10. SELGAPC1 outputs are used to
route inputs to different functions. By setting SELGAPC1, binary inputs can be
configured for different purposes.
1MRS757456 D Section 3
REF611 standardized configurations
REF611 51
Application Manual