ABB REF611 - Internal Signals

ISWGAPC2
IN
OUT_1
OUT_2
OUT_3
OUT_4
OUT_5
OUT_6
OUT_7
OUT_8
OUT_9
OUT_10
OUT_11
OUT_12
Blocking 2
SELGAPC1_OUT_12
PHLPTOC1_BLOCK
PHHPTOC1_BLOCK
PHHPTOC2_BLOCK
PHIPTOC1_BLOCK
EFLPTOC1_BLOCK
EFLPTOC2_BLOCK
EFHPTOC1_BLOCK
EFIPTOC1_BLOCK
NSPTOC1_BLOCK
NSPTOC2_BLOCK
PDNSPTOC1_BLOCK
T1PTTR1_BLOCK
OUT_13
CBPSOF1_BLOCK
GUID-4E83752D-09FE-46D7-AA9F-82C9609C59E8 V2 EN
Figure 76: ISWGAPC2
3.5.4.2 Internal signals
The internal signal group is used to configure logic connections between function
blocks. There are two ISWGAPC instances, one SELGAPC and one OSWGAPC
instance in this group.
ISWGAPC3 is used to configure which protection function enables current multiplier
if inrush is detected by the INRPHAR1 function. ISWGAPC4 is used to configure the
cooperation between the autoreclose function and protection functions. Autoreclose
function DARREC1 can block protection functions according to the application.
SELGAPC2 is used to configure TCS blocking from the circuit breaker open or close
position. OSWGAPC17 is used for connecting switch onto fault function CBPSOF.
The inputs are start signals routed from the protection functions.
1MRS757456 D Section 3
REF611 standardized configurations
REF611 97
Application Manual