IEC09000357 V1 EN
Figure 63: Select the TCP/IP protocol and open Properties
4. Select Use the following IP address and define IP address and Subnet mask if
the front port is used and if the IP address is not set to be obtained
automatically by the IED, see
Figure 64. The IP address must be different from
the IP address chosen for the IED.
IEC09000658 V1 EN
Figure 64: Select: Use the following IP address
5. Use the ping command to verify connectivity with the IED.
6. Close all open windows and start PCM600.
Section 8 1MRK 502 029-UEN A
Set up the PCM600 communication link per IED
100
Installation and commissioning manual
To Next Page
Loading...
