ABB RET615 D - Signals

8.1.9.3 Signals
Table 562: CSMSQI Input signals
Name Type Default Description
I
0
SIGNAL 0 Zero sequence current
I
1
SIGNAL 0 Positive sequence current
I
2
SIGNAL 0 Negative sequence current
8.1.9.4 Settings
Table 563: CSMSQI Non group settings
Parameter Values (Range) Unit Step Default Description
Operation 1=on
5=off
1=on Operation Off / On
Ps Seq A Hi high Lim 0.00...40.00 xIn 1.40 High alarm current limit for positive
sequence current
Ps Seq A high limit 0.00...40.00 xIn 1.20 High warning current limit for positive
sequence current
Ps Seq A low limit 0.00...40.00 xIn 0.00 Low warning current limit for positive
sequence current
Ps Seq A low low Lim 0.00...40.00 xIn 0.00 Low alarm current limit for positive
sequence current
Ps Seq A deadband 100...100000 2500 Deadband configuration value for
positive sequence current for integral
calculation. (percentage of difference
between min and max as 0,001 % s)
Ng Seq A Hi high Lim 0.00...40.00 xIn 0.20 High alarm current limit for negative
sequence current
Ng Seq A High limit 0.00...40.00 xIn 0.05 High warning current limit for negative
sequence current
Ng Seq A low limit 0.00...40.00 xIn 0.00 Low warning current limit for negative
sequence current
Ng Seq A low low Lim 0.00...40.00 xIn 0.00 Low alarm current limit for negative
sequence current
Ng Seq A deadband 100...100000 2500 Deadband configuration value for
negative sequence current for integral
calculation. (percentage of difference
between min and max as 0,001 % s)
Zro A Hi high Lim 0.00...40.00 xIn 0.20 High alarm current limit for zero
sequence current
Zro A High limit 0.00...40.00 xIn 0.05 High warning current limit for zero
sequence current
Table continues on next page
1YHT530004D05 D Section 8
Measurement functions
615 series 643
Technical Manual