Programming
33
Programming
Overview
This chapter gives information on configuring the PROFIBUS
master station and the drive for communication through the
RPBA-01 PROFIBUS DP Adapter module.
Configuring the system
After the RPBA-01 PROFIBUS DP Adapter module has been
mechanically and electrically installed according to the instructions
in previous chapters, the master station and the drive must be
prepared for communication with the module.
Configuration of the master station requires a type definition
(GSD) file. For DP-V0 communication, the file is available from
profibus website
or an ABB representative (the filename is
ABB_0812.GSD). For DP-V1 communication, the type definition
(GSD) file is available from an ABB representative (the filename is
ABB10812.GSD).
Please refer to the master station documentation for more
information.
PROFIBUS connection configuration
The detailed procedure of activating the module for
communication with the drive is dependent on the drive type.
(Normally, a parameter must be adjusted to activate the
communication. See the drive documentation.)
As communication between the drive and the RPBA-01 is
established, several configuration parameters are copied to the
drive. These parameters – shown below in Table 5 – must be
checked first and adjusted if necessary. The alternative selections
for these parameters are discussed in more detail below the table.
To Next Page
Loading...
