DP-V1 communication
74
6 RAMP_IN_
ZERO
1 Normal operation. Proceed to OPERATING
0 Force Ramp Function Generator input to zero
Note: The function of this bit may depend on the ramp
parameter settings of the drive. See the drive documentation.
7 RESET 0 ⇒ 1 Fault reset if an active fault exists. Proceed to SWITCH-
ON INHIBIT.
0 (Continue normal operation)
8 INCHING_1 Inching 1. (See the drive documentation for information)
9 INCHING_2 Inching 2. (See the drive documentation for information)
10 REMOTE_
CMD
1 Fieldbus control enabled
0 Control Word <> 0 or Reference <> 0: Retain last Control
Word and Reference
Control Word = 0 and Reference = 0: Fieldbus control
enabled
11 Vendor-specific bit as defined by PROFIdrive parameter
933.
12 Vendor-specific bit as defined by PROFIdrive parameter
934.
13 Vendor-specific bit as defined by PROFIdrive parameter
935.
14 Vendor-specific bit as defined by PROFIdrive parameter
936.
15 Vendor-specific bit as defined by PROFIdrive parameter
937.
Bit Name Value Proceed to STATE/Description
To Next Page
Loading...
