ABB SACE PR010/T - Reading Data from SACE Relays; Measuring Functionality; Parameters and Configuration Display

ABB SACE ABB SACE PR010/T RH0029002 L4408 11/29
29
2.3 Reading
The data available in the Reading mode with the various different SACE relays is given in the
table below.
2.3.1 Measuring
The measurements are displayed in absolute values (e.g.: Amperes for the current values, Volts
for the voltage values). The reading of a nil or unavailable value (because it is too low) is
indicated by: “...” or an empty space.
2.3.2 Parameters/Configuration
This section displays the relay's configuration parameters and information, including the size of
the CB, the neutral setting, the version of the relay, the language, frequency setting, the rated
voltage, the external contacts, etc.
The availability of information depends on the maximum performance of the relay, as indicated in
the relative table. Scroll the menu to display the data of the DEFAULT version (this function is
available with up to 7.5 SW versions of the PR010/T unit 7.5).
Use the  and  keys of ENTER to scroll the sections.
PR111 PR111/VF PR112 PR113 PR212 PR212MP PR222 PR222MP PR223EF PR223DS
READING
Current measuring
XXXXXXXX
Other measurements
X
(1) X(2) XX(2) X(3) X(1)
Parameters/
Configuration
(4)
XXXXXXXX
Protections
XX X XX
Trip history
XXXX
(4) XXX
General information
XXXXXXXX
NOTES
1
Voltage, Power, Energy Counter, Power Factor, Frequency and peak factor measurements available
2
Readings of generic input 0/1 available
3
Voltage, Frequency and peak factor measurements available if accessory module VM210 is installed
4
Trip history reading available for relay versions /PD
RH0029002.book Page 11 Thursday, May 5, 2011 12:14 PM