ABB SACE PR112 - 14.2 Indications on operation

ABB SACE SACE PR010/T RH0029002 L2551 46/67
67
14.2 Indications on operation
• The SACE PR010/T unit may be used with all SACE PR122/P releases connecting the test
unit to the protection unit by means of a special cable to the functional test connector.
PR122 UNIT
Protection
parameters
1. L prot.
2. S prot.
3. I prot.
4. G prot.
5. Ext G prot.
6. U prot.
7. T prot.
8. LC1 prot.
9. LC2 prot.
10. Iw prot.
11. Rc prot.
12. MCR prot.
13. UV prot.
14. OV prot.
15. RV prot.
16. RP prot.
17. UF prot.
18. OF prot.
1. Protection L parameters
2. Protection S parameters
note 5
3. Protection I parameters
4. Protection G parameters
note 6
5. Protection Ext G parameters
note 6
6. Protection U parameters
7. Protection T parameters
8. Protection LC1 parameters
9. Protection LC2 parameters
10. Protection Iw parameters
11. Protection Rc parameters
note 1
12. Protection MCR parameters
13. Protection UV parameters
note 2
14. Protection OV parameters
note 2
15. Protection RV parameters
note 2
16. Protection RP parameters
note 2
17. Protection UF parameters
note 2
18. Protection OF parameters
note 2
NOTES
1
Only for performing LSIG (with measuring module) or LSIRc and presence of residual current
in the external toroide.
2
Only if measuring module present.
3
Only if communication module present.
4
Only if signalling module present.
5
Only for performing LSI or LSIG or LSIRc.
6
Only for performing LSIG.