ABB SACE PR112 - 6.1 Operation mode menu tree

ABB SACE SACE PR010/T RH0029002 L2551 19/67
67
6.1 Operation mode menu tree
1° 2° 3° 4° 5° 6° 7° 8° 9°
1. Operation mode
8. Select DUT (PR223EF)
1. Test
1. Protections 1. Automatic Start test (select Electronic Set)
Create
test
report
2. Manual 1. Default
setting
Start test
2. User
setting
Set parameters Start test
2. Trip
Start test
2. Reading
1. Measurements 1. Currents Read measured currents
2. Voltages Read measured line and phase voltages
3. Frequency Read measured frequency
4. Peak factor Read peak factors
2. Last trip
Display data of last 20 trips
3. Config./param.
1.DUT config. Display DUT configuration and parameters
2. DUT
parameters
Display protection parameters
3. Default
parameters
1. For test Display default test parameters
2. Operative
Display default operative parameters
4. Communication
par.
Display communication parameters for system bus
5. Information
Read release identification, SW version and Serial Number
3. Programming
1. Parameters Change DUT protection parameters Store protection
unit parameters
2. Default
download
Program DUT with default operative parameters defined
in "programming/Define Default/Operative"
3. Define default
1. Only for
test
Define default par. used for: "Test/
Protections/Manual/Default set"
Store parameters
in the PR010/T
test unit
2. Operative Define default par. for: "Program/Default
download"
4. Communication
par.
Define communication par. for system bus Store protection
unit parameters