ABB SAM600 Series - Page 25

IEC18000114 V1 EN-US
Figure 11: PCM600: Access Point configuration
If the SAM600 module connected to PCM600 is already configured, then
the access point information is fetched from the configuration on the
SAM600 system. If the SAM600 system is in factory default settings, then
access points are not read.
9. Click the Next button to open a SAM600 system - Summary Page, see Figure 12. The
dialog box displays
Custom Name , Module Type , Hardware Type , Serial Number and
Available Access Points details. It is possible to cancel the insertion using Cancel button
or confirm the configuration and do the insertion using Finish button.
IEC18000115 V1 EN-US
Figure 12: PCM600: SAM600 system Setup completion wizard
If an error occurs, cancel the insertion and reinsert a SAM600 system into
PCM600.
1MRK 511 433-UEN B Section 4
Setting up a project
SAM600 Process Bus I/O System 17
Engineering manual
© Copyright 2017 ABB. All rights reserved