IEC18000112 V1 EN-US
Figure 9: PCM600: Online version detected
7. Click the Scan button to scan or read the SAM600 hardware modules and the connection
topology for a SAM600 system that is online, see Figure 10.
IEC18000113 V1 EN-US
Figure 10: PCM600: Hardware Module and connection topology detected
If the SAM600 module connected to PCM600 is already configured, then
the topology information is fetched from the configuration on the
SAM600 system. If the SAM600 system is in factory default settings, then
the physical topology is discovered.
Based on the physical topology, SAM600 system can either be connected
in daisy chain or ring system.
8. Click the Next button to open a SAM600 system Access Point Selection page, see Figure
11.
Section 4 1MRK 511 433-UEN B
Setting up a project
16 SAM600 Process Bus I/O System
Engineering manual
© Copyright 2017 ABB. All rights reserved
To Next Page
Loading...
