2 - 12 WBPEEUI240751C0
CIO-110
CIO-110
Electric Drive/Pulse Positioner Termination
The CIO-110 block is an auxiliary block used with a CIO-100
block to connect a manual/auto station that operates in elec-
tric drive/pulse positioner bypass mode. The CIO-110 block
provides the terminals necessary for proper wiring connection.
The CIO-110 block cable connects to the CIO-100 block.
DI
Fault currents per channel:
24 VDC
48 VDC
125 VDC
120 VA C
240 VA C
Each channel provides current limiting and automatic recovery
31 mA nominal
8.1 mA nominal
14 mA nominal
15 mA nominal
15 mA nominal
DO
Open collector outputs
Update rate All channels 63 times per second (16 msec)
Switching speed <0.25 msec
OFF leakage current <1 mA
Station connectors 2
Station fuse (24 VDC LFP) 6.3 A, 250 V, 5 x 20 mm, time-lag, medium break capacity
(IEC 127-2/VI)
Station link (RS-485) 40 kbaud
BLP fuse (A and B) 1.6 A, 250 V, 5 x 20 mm, fast-acting, low break capacity
(IEC 127-2/II)
IFP/LFP fuse 3.15 A, 250 V, 5 x 20 mm, time-lag, medium break capacity
(IEC 127-2/VI)
Weight
Module
Base
1.0 kg (2.2 lb)
1.4 kg (3.1 lb)
NOTES:
1. All specification values are maximums unless stated otherwise.
2. Maximum error includes effects of nonlinearity, repeatability, hysteresis, noise, and quantization error.
3. This is the rate at which the block reads and updates values. The rate at which the values are actually read and become avail-
able to the system depends on the scan cycle of the controller.
4. Software selectable in 1-msec increments up to 255 msec (debounce period).
5. Actual input current depend s on inp ut type selection.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTIC E
Table 2 -7. CIO-100 Specifications
(continued)
Property Characteristic/Value
1
Output Off On Load
24 VDC 28 VDC 2.5 VDC 250 mA
To Next Page
Loading...
