PR1 - 2 WBPEEUI240751C0
I/O and Auxiliary Block Considerations
the previously listed items have not been completed before
beginning any I/O and auxiliary blocks installation.
□
2. Verify the internal enclosure locations for I/O and auxiliary
blocks to be installed. Refer to I/O and Auxiliary Block Con-
I/O and Auxiliary Block Con-I/O and Auxiliary Block Con-
I/O and Auxiliary Block Con-
siderations
siderationssiderations
siderations in this section.
□
3. Fill out the appropriate I/O block worksheets as necessary.
Information recorded on these worksheets is needed in the
installation procedures that follow.
NOTE: The worksheets are only intended to aid in the installation process. In
some cases, the information recorded on the worksheets may already be avail-
able or provided in some other form. In these cases, filling out the worksheets
is not necessary.
Table PR1-1 provides a listing of worksheets. The worksheets
are located towards the back of the instruction in the WS sec-
tions. Refer to I/O Block Worksheets
I/O Block WorksheetsI/O Block Worksheets
I/O Block Worksheets in this section for more
information.
I/O and Auxiliary Block Considerations
Keep the following considerations in mind when locating I/O
and auxiliary blocks:
1. An enclosure can contain more than one repeater mount-
ing unit. The units are typically located on the first column.
2. Position an auxiliary block directly above or below its I/O
block.
3. Install blank blocks in any empty slots to maintain air flow
through a block column. Blank blocks are not needed, how-
ever, to fill positions at the bottom of a column.
Table PR1-1. Worksh eets
I/O Block Worksheet I/O Block Worksheet
AIN-120 WS1 CIO-100 WS6
AIN-200 WS2 DIO-400 WS7
AIN-220 WS3 DOT-100 WS8
AIN-300 WS4 DOT-120 WS9
AOT-150 WS5
NOTE: Ma ke copies of worksheets and mainta in the originals in this instruction.
To Next Page
Loading...
