ABB Symphony Harmony Series - Page 352

WBPEEUI240751C0 WS8 - 1
WS8
DOT-100
Field Power Options
NOTE: 24 VDC IFP or LFP is needed to power the output relay coils.
Digital Outputs - FC 225
Block ID: ____________________________________________________________________
Location: ____________________________________ Column: _______ Row: _______
Device Label: _______________________________________________________
(32 characters max.)
Internal Field Power (IFP): ! 24 VDC (always available)
Local Field Power (LFP): " 24 VDC " None
Field Power Selection: " IFP " LFP
CH1 Channel Info: ____________________________________________________________
Channel Label: _________________________________________
(optional 32 characters max.)
Output: " Normally open " Normally closed
Stall State: " On (0) " Off (1) " Hold Output
CH2 Channel Info: ____________________________________________________________
Channel Label: _________________________________________
(optional 32 characters max.)
Output: " Normally open " Normally closed
Stall State: " On (0) " Off (1) " Hold Ouput