PR5 - 2 WBPEEUI240751C0
Procedure
base line up with the alignment holes on the back of the
module.
NOTE: Do not use the fastening screw to align the blank module.
c. Gently push the module in until the front of the base
and the front of the module are flush. This should not
require much pressure. If the module cannot be pushed in
flush with the base, then it is not properly aligned.
Figure PR5-1. Base Attachment
T00910B
ALIGNMENT
HOLES
IN S E R T TA B S
IN S L O TS
CAPTIVE
FA S T E N IN G
SCREWS
REAR VIEW
To Next Page
Loading...
