Operation Manual / TPS48-D/E.. - TPS61-D/E..
Page 33
April 2015 HZTL2410_EN Revision D
2.10
Loads not suspended in compliance with regulations may lead to
personal injury or accidents with fatal consequences.
Loads must always be fastened to technically perfect lifting gear with
sufficient loading capacity.
Make sure the load is suspended properly on the crane hook.
Do not let anyone stand beneath a suspended load.
Wear safety gloves against mechanical risks.
Wear safety helmet.
In the case of two or more suspension points, the slinging angle must not
exceed 45°. This avoids excessive loading due to inclined tensile loading.
Fasten turbocharger assemblies / components as described in
respective handling steps.
Before attaching slings, allow turbocharger components to cool down
(maximum 80°C).
Use suitable protection at sharp edges.
Completely screw in assembly / fitting devices without fail so that they
cannot work loose during use.
Use assembly / fitting devices only for applications described.
Make sure removed turbocharger components stand safely and
securely.
© Copyright 2015 ABB. All rights reserved.
To Next Page
Loading...
