ABB TPS 48D01 - 3.3 Commissioning after taking out of operation

Operation Manual / TPS48-D/E.. - TPS61-D/E..
Commissioning
3
Commissioning afte
r taking out of
operation
3.3
Page 41
April 2015 HZTL2410_EN Revision D
Commissioning after taking out of operation
3.3
 Remove cover plates (blind flanges) between compressor casing
outlet and charge air duct, before gas inlet and after gas outlet.
 Inspect exhaust gas duct / line in front of and after turbine for any
combustion deposits, foreign matter or residual water. Clean and
remove.
 Inspect air supply line or filter silencer for any foreign matter. Clean
and remove.
 Start up turbocharger oil circulation system at engine end.
 Prepare turbocharger for operation as instructed in section "Inspection
work before start-up / commissioning" of chapter headed "Start-up /
commissioning".
 Start up turbocharger.
3.3
If provided
© Copyright 2015 ABB. All rights reserved.