- 14 -UMC100-FBP
Universal Motor Controller
UMC100-FBP
Technical Description
V 6
FieldBusPlug / Issue: 03.2012
VI150-FBP
The VI150-FBP adds voltage and power protection functions to the UMC-FBP. It provides three voltage
inputs with a nominal range from 110 V AC - 690 V AC and one relay output.
The module can be used with grounded systems only (e.g. TN-C / TN-S systems
according to IEC 60364).
The following figure shows the terminals and monitoring elements of the VI150-FBP module.
1C a 1 C b
2C a 2 Cb
RDY
Diag
ERR
0V 24V DC NC
DOC DO0 NC
NC L2 NC
L1 NC L3
Terminals
for the
24 V DC supply
Connecting terminals
for communication with
the UMC100
and further IO modules.
Connecting terminals
for the line voltage
inputs.
LEDs
green READY = operation
yellow DIAG = warning
red ERROR = module fault
Connecting terminals
for the relay output
Front label,
e.g. for slave address
VI155-FBP
The VI155-FBP adds voltage and power protection functions to the UMC-FBP. It provides three voltage
inputs with a nominal range from 110 V AC - 690 V AC and one relay output.
The module can be used with grounded and ungrounded systems (e.g. TN or IT-sys-
tems according to IEC 60364).
The following figure shows the terminals and monitoring elements of the VI155-FBP module.
1C a 1 C b
2C a 2 Cb
RDY
Diag
ERR
0V 24V DC NC
DOC DO0 NC
NC L2 NC
L1 NC L3
Terminals
for the
24 V DC supply
Connecting terminals
for communication with
the UMC100
and further IO modules.
Connecting terminals
for the line voltage
inputs.
LEDs
green READY = operation
yellow DIAG = warning
red ERROR = module fault
Connecting terminals
for the relay output
Front label,
e.g. for slave address
To Next Page
Loading...
