- 15 - UMC100-FBP
Universal Motor Controller
UMC100-FBP
Technical Description
V 6
FieldBusPlug / Issue: 03.2012
Configuration Tool
Asset Vision Basic is the tool to configure the UMC100-FBP via a Laptop. Asset Vision Basic is jointly
used between ABB Instrumentation and ABB Control Products. Therefore it enables a wide range of
ABB products to be configured such as motor controllers, soft starters, flow meters and many more.
It is based on the FDT/DTM standard which also enables the configuration of third-party products that
are connected at the same bus segment.
You can parameterise the UMC100-FBP both online and offline.
In offline mode the configuration can be fully prepared and then later on loaded into the device(s).
If a connection to a device exists, monitoring of all measured values, maintenance counters etc. is
possible.
Tree view of
all devices on
the bus line
Toolbar & Menus
Status Window
The diagram above shows the configuration tool which allows intuitive configuration of all
UMC100 functions.
In this example the window to configure the motor protection parameters is shown.
In similar windows all other parameters can be configured.
Other views enable the monitoring of the diagnosis information, the visualisation of bus monitoring,
command data and much more.
UMC100-FBP configuration tool Asset Vision Basic with the motor protection configuration
window (3). In (1) the toolbar of the tool is shown. (2) provides a network view with all the
devices accessible on the PROFIBUS DP line. (4) contains a window to display messages
and buttons to quit or adopt the parameter changes.
Configuration
window
of the
motor protection
functions
To Next Page
Loading...
