Besides the Regulatory label, an additional product label is also provided.
The label displays the following information:
An additional Wireless Identication label is provided.
The label displays the following information:
The Wireless Identication label is divided in two separate parts by a dashed line; take the
bottom part and apply it on the cover page of the quick installation guide.
The ofcially required information is located on the Regulatory label. The product label or the
Wireless Identication label are accessory labels which shows the information necessary for
the identication and characterisation of the inverter by ABB.
Note: The labels are NOT to be hidden by foreign objects and parts (rags, boxes, equipment,
etc.); they must be regularly cleaned and always kept in sight.
• Inverter model
- X.X = Inverter power rating:
- X = Integrated disconnect switch (-S)
- Y = Integrated WLAN board (-B)
• Inverter Part Number
• Inverter Serial Number consisting of:
- YY = Year of manufacture
- WW = Week of manufacture
- SSSSSS = sequential number
• Week/Year of manufacture
P/N:PPPPPPPPPPP
WO:XXXXXXX
SO:SXXXXXXXX Q1
SN:YYWWSSSSSS WK:WWYY
UNO-DM-X.X-TL-PLUS-US-XY-RA
ABB
• WLAN board Serial Number
• WLAN Board Part Number
• Inverter Serial Number
• WLAN Board MAC address:
- To be used to obtain the SSID of the wireless access point
created by the inverter: ABB-XX-XX-XX-XX-XX-XX
(where “X” is a hex digit of the MAC address).
- To be used to obtain the “Host Name”:
http://ABB-XX-XX-XX-XX-XX-XX.local
(where “X” is a hex digit of the MAC address).
- MAC address it’s the only required information to register the
inverter with Aurora Vision.
• Product Key:
To be used as wireless access point password, after 24 hours
which the inverter is power on (then the default password
“ABBSOLAR” is expired) or to be used to access to the internal
webserver as username and password in case of lost credentials.
To Next Page
Loading...
