- 4 -
000620AG
Warranty and conditions of sale
The terms and conditions of sale, including requirements for maintaining
the warranty, are sent with each order. Refer to the terms and conditions
when designing the site, installling the inverter and setting up a
preventative maintenance program.
In particular, pay attention to physical clearances, any site noise limitations,
maximum system input voltage, potential ammability hazards.
ABB accepts no liability for failure to comply with the instructions for correct installation and is
not responsible for equipment it has not supplied.
Any modication, manipulation, or alteration of the hardware or software, voids the warranty.
ABB is not liable for for defects or malfunctions arising from improper
use of the equipment, failures or problems due to shipping damage or
out-of-spec environmental conditions; lack of or incorrect preventative
maintenance, tampering or repairs; use or installation by unqualied
persons.
1
Introduction and general information
To Next Page
Loading...
