The parameters relating to the home wireless network (set
on the router) that must be known and set during this step
are:
-
IP Settings: DHCP or Static.
If you select the DHCP function (default setup) the rou-
ter will automatically assign a dynamic IP address to the
inverter whenever it tries to connect to the user network.
With Static, the user can assign a xed IP address to
the system. The data which has to be entered in order
for IP static address assigning to take place will appear.
Complete the additional elds at the bottom of the scre-
en (all the elds are mandatory with the exception of the
secondary DNS server).
- Available networks (SSID):.
Identify and select your own (home) wireless net-
work from all those shown in the SSID eld (you
can carry out a new search of the networks that
can be detected with the Update button ).
Once the network has been selected, conrm.
-
Password: Wireless network password.
Enter the password for the destination network (if neces-
sary) and start the connection attempt (it will take a few
seconds).
Click on “Connect” button to switch the inverter wireless
connection from point to point to the home wireless net-
work.
A message will ask for conrmation. Click “Next” to con-
nect the inverter to the home wireless network.
To Next Page
Loading...
