ABB WaterMaster FET100 - Cable Preparation (Remote Systems Only)

WaterMaster FET100
Electromagnetic floweter | Transmitter 3 Electrical Installation
OI/FET100–EN Rev. A 11
3.3 Cable Preparation (Remote Systems Only)
To prepare the cable for connection at the transmitter and sensor terminal blocks:
1. Remove the outer cable insulation and Mylar
®
wrap.
2. Ensure the drain wire is sleeved.
3. Cut the cable connection wires to the lengths shown in Fig 3.5, page 12.
Fig. 3.4 Cable Gland / Conduit Entry (Remote Transmitter Shown)
AC/DC Power
Supply Terminal
Power Cable Output Connections
External Earth
Output Connections
Sensor Cable
Output
Connections
Termi n a l
Sensor
Cable Terminal
Backplane
Internal Earth
(Alternative PE)
Internal Earth
(Alternative PE)
Te s t P o in t s f o r
Output Connections