ABB XRC G5 - Digital Input and Output (DI;DO) Pinouts XFC DI;DO; Figure 6-2: XRC AI Terminals and Input Mode Selector Jumpers

52 | XSE RI ES G5 | 210602 6MNAA
Figure 6-2: XRC AI terminals and input mode selector jumpers
Table 6-5: XRC AI Pinouts
Input
Pin
Description
AI-1
1
(+) Input signal
2
(COM) Input ground
AI-2
3
(+) Input signal
4
(COM) Input ground
AI-3
5
(+) Input signal
6
(COM) Input ground
AI-4
7
(+) Input signal
8
(COM) Input ground
AI-5
9
(+) Input signal
10
(COM) Input ground
The XFC
G5
has 2 onboard digital outputs and 2 onboard digital inputs. Figure 6-3 shows the Digital I/O
terminals on the XFC
G5
and the input mode switches. The input mode switches support standard pulse
inputs (STD) or pulse inputs from Coriolis (IEC). Remember to set the switch to the correct position
based on the type of pulse input signal expected. Use S3 for DI/PI 1 or S4 for DI/PI 2.
Listed below are the DIs and DOs for the XFC
G5
.
Figure 6-3: XFC
G5
DI/PI/DO terminals and input mode switches
Table 6-6: XFC
G5
DI/PI/DO pinouts
I/O
Pin J6
Description
DI2/PI2
1
(+) Input signal
2
(-) Input ground
DI1/PI1
3
(+) Input signal
4
(-) Input ground