Abit SL6 - Page 67

BIOS Setup 3-37
User’s Manual
➤ User Define
“User Define” defines the delay for accessing the power modes.
Suspend Mode: Disabled ) 1 Min ) 2 Min ) 4 Min ) 8 Min ) 12 Min ) 20
Min ) 30 Min ) 40 Min ) 1 Hour. The default setting is
Disabled.
HDD Power Down: Disabled ) 1 Min ) 2 Min ) 3 Min ) 4 Min ) 5 Min ) 6
Min ) 7 Min ) 8 Min ) 9 Hour ) 10 Min ) 11 Min ) 12
Min ) 13 Min ) 14 Min ) 15 Min. The default setting is
Disabled.
➤ Min Saving
When these two saving modes are enabled, the system is set up for minimum power
savings.
Suspend Mode = 1 Hour
HDD Power Down = 15 Min
➤ Max Saving
When the two saving modes are enabled, the system is set up for maximum power
savings.
Suspend Mode = 1 Min
HDD Power Down = 1 Min
Video Off Method:
Three video off methods are available: "Blank Screen", "V/H SYNC + Blank" and "DPMS".
The default is " V/H SYNC + Blank ".
If this setting does not shut off the screen, select “Blank Screen”. If your monitor and video
card support DMPS standard, select “DPMS”.
Blank Screen: This option only writes blanks to the video buffer.
V/H SYNC + Blank: This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
DPMS: Initial display power management signaling.
Video Off In Suspend:
Two options are available: Yes or No. The default setting is Ye s. This item determines the
manner in which the monitor is blanked.