| Configuring the Wallbox eMH2 – Stand-alone operation of a Slave wallbox
20
18 In the dialog box that pops up, click OK.
y The new setting is now being transferred to
the wallbox.
y The Devices field now shows the device
RFIDM60 - standalone CONFIG MODE.
19 In the Devices field, click on the device
RFIDM60 - standalone CONFIG MODE.
20 Click the Device specification > Leave config
mode button.
21 In the dialog box that pops up, click OK.
y The new setting is now being transferred to
the wallbox.
y The Devices field now shows the device
RFIDM60 - standalone CONFIG MODE.
22 Close the Configuration Software application using the X button in the top right corner of the application
window and click OK in the dialog box that pops up.
23 Disconnect the computer from the wallbox.
y If connected via USB interface:
Unplug the USB extension cable from the USB
port in the wallbox and from your computer's
USB port.
y If connected via LOMK218:
Disconnect the RS485-RJ12 adapter from the
spring terminals in the wallbox. You can also
unplug the USB-RS485 cable from the RS485-
RJ12 adapter and from your computer's USB
port.
A M B
CONTROL
A M B
METER
A M B
CONTROL
A M B
METER
To Next Page
Loading...
Need help?
General
