Notes in a Sequence in Clip View.
In Clip View, you can also press and hold a pad or group of pads within
a step to bring up various editing controls, such as Nudge, Length,
Velocity, etc. in the display, which you can adjust using the encoders.
Edit Options When Holding Pads in a Step.
As with the 64 Notes pad grid layout, pressing the Octave Up or Octave
Down buttons shifts the range of available notes by an octave. You can
hold the Shift button and press the Octave Up or Down buttons to shift
the range by one note in the scale. The updated range will be shown in
the display as you move up or down.
You can also use the touch strip to change the octave range. Hold Shift
and then slide your finger up and down the touch strip to switch
between octaves, or slide your finger along the touch strip without
holding Shift to move between notes in the scale.
7.3.1 Loop Length Controls
You can use the loop length controls to set the length of the loop, as
well as specify which part of the loop you can see and edit in the
Melodic step sequencer.
Hold the Layout button to momentarily display the loop length pads on
the top row of the grid. To lock the Loop Selector in place, hold Shift
and then press Layout. To unlock the Loop Selector, press the Layout
To Next Page
Loading...
Need help?
General
