selected as the step size. In this case, these pads are not active,
only the first six pads in each row of steps can be used.
You can adjust the loop length and access additional step sequencing
pages via the loop length controls. Hold the Layout button to
momentarily access the loop length pads in the fifth row of the pad
grid. To lock the Loop Selector in place, hold Shift and then press
Layout. To unlock the Loop Selector, press the Layout button again.
The locked/unlocked state will be stored for each track.
To copy a page of steps, hold Duplicate and press the loop length pad
for the page you want to duplicate, then press the loop length pad for
the destination page. Note that this will not remove any existing steps
in the destination page, but will add the copied ones on top. If you want
to remove all of the steps on a page before pasting copied ones, hold
Delete and tap the loop length pad for that page.
8 Recording MIDI
Push allows you to record MIDI signals when playing instruments
directly on the hardware or when using external instruments. With
different recording options available such as fixed length recording or
recording with repeat, quantizing notes during or after recording, and
even the ability to capture beats and melodies as clips without pressing
the Record button, you can use Push to freely explore different creative
avenues.
When working in Note Mode, MIDI tracks are automatically armed for
recording. In Session Pad Mode, you’ll need to arm tracks manually. To
do this, press and hold the display button under the track name, or hold
the record button and then press the track’s lower display button. A
To Next Page
Loading...
Need help?
General
