navigate through and select devices. Unlike Browse Mode, however,
selecting a device does not automatically close Swap Mode and go
back to the Device View. This means you can continue selecting and
trying out sounds until you find what you’re looking for.In addition to
using the jog wheel and Session D-pad, you can also use the Load Next
and Load Previous buttons to automatically switch between devices
without having to individually select them first.
When a device is selected in Hot-Swap Mode, you can play the pads to
test out the new sounds. You can also enable Preview to hear a sound
snippet of each device as you scroll through the list of presets.
When selecting a new device or using the Load Next or Load Previous
buttons, the device is automatically added to the track, replacing the
original one. To add the original device back to the track, you can select
it from the device menu again.
To exit Hot-Swap Mode, press the Swap button again or the display
button above the device name.
4.2.2 Track Options
You can access additional track options by holding Shift and then
pressing the display button under the track name.
Track Options.
Use the corresponding lower display buttons to select an option.
To Next Page
Loading...