CR7P
Digital Proportional Radio Control System
4
Danger • Do not use the battery if damaged
Battery type: AA batteries or 2S lithium batteries JST interface inside the battery compartment.
Please follow the steps below to install the transmitter batterieses:
1. Open the battery compartment cover.
2. Put 4 AA batteries with sufficient electricity into the battery compartment. Ensure that the
metal terminals on the batteries contact the metal terminals inside the battery compartment.
You should choose the proper size of 2S 7.4V lithium battery to access the JST interface. Connect
them correctly.
3. Cover the battery compartment.
3.2 Installing Receiver and Servo
Install the receiver and servo in the following methods:
3. Preparation
Prior to operations, please install the battery and connect devices according to the sequence
and guide as described in this chapter.
3.1 Installing Transmitter Battery
Danger • Do not open, disassemble, or attempt to repair the battery.
Danger • Only use specified battery (4 x AA batteries).
Danger • Do not crush/puncture the battery, or short the external contacts.
Danger • Do not drop the battery or expose to strong shocks or vibrations.
Danger • Do not expose to excessive heat or liquids
Danger • Always store the battery in a cool, dry place.
To Next Page
Loading...
