Absima CR7P - 4. Operation Guide; 4.1 Power-on Procedure; 4.2 Binding Transmitter and Receiver; 4.3 Transmitter LED and Audio Settings

5
4. Operation guide
After the preparation is completed, you can start to use the product according to the guide in
this chapter.
4.1 Power-on
Power on the product according to the following steps:
1. Check the system status to make sure the battery is fully charged and properly installed.
2. Turn the switch to the [On] position. The screen will light up.
3. Power on the receiver.
Warning
• At this point, the system starts. Please operate carefully. Otherwise, it may cause damage to the
product or injury to people.
Warning • For your safety, please turn the transmitter switch and throttle to the safe position.
4.2 Bind
The ex-factory bind settings of the transmitter and receiver are completed successfully.
If you need to replace the transmitter or receiver with another one, please follow the steps below
for binding:
1. Connect the power cable to the VCC/BVD interface on the receiver. At this time, the receiver
indicator flashes slowly;
2. Press and hold the BIND key on the receiver for more than 3 seconds or press and hold the BIND
key on the receiver for power-on.
3. Power on the transmitter and set the receiver. In the BIND SET, select the BIND: START. At this
time, the system is in bind mode.
4. After the bind is successful, the receiver LED is always on, and the transmitter automatically
exits the bind state;
5. After the bind is completed, you can use it normally.
4.3 Setting Transmitter LED and Audio
This LED is a monochromatic light. You can set the ON and OFF state. You can enable or disable the
audio for the system operations and alarms. For system operations and alarms, you can enable/
disable the audio separately or collectively. In addition, you can set the audio volume separately.
• The procedure is applicable to the bind between only CR7P transmitter and R7FS receiver. The bind
methods vary with receivers. For details about the operations, you can visit the Absima official
website to obtain the receiver manual or other related information.
• Since the product is constantly updated, please visit the ABSIMA official website to obtain the
latest transmitter and receiver compatibility list.
This product system is compatible with most of our ANT Protocol receiver models. The details are as
follows:
RF standard: 2.4 GHz Ant protocol
Receiver model: R7FS
Position of BIND KEY