Abus NVR10020P - Page 31

31
Important: The installed hard disk drives have to be initialised before the device can
be used for recording. All data will be deleted from the hard disk drive during
initialisation.
Important: If only one hard disk drive is installed and this is set to "Read-only", the
device cannot be used for recording.
No.
Number of hard disk drives installed / NAS drives added
Capacity
Shows the storage space in GB
Status
Shows the current status of the hard disk drives:
• Not initialised
• Normal
• Error
• Standby
Attributes
Shows the access status of the hard disk drive:
• Read-only: write protection
• R/W: read and write
Type
Shows the type of connection for the hard disk drive:
• Local: device hard disk drive
• NAS: Network hard disk drive (NHDD)
• IP SAN: iSCSI volume
Free Space
Shows the free storage space
Group
Shows which group the hard disk drive has been assigned to
Edit
You can change the group assignment and access status here
• HDD No.: Internal numbering system for the hard disk drives
• R/W: In this mode, video data is written onto the hard disk
drives and can also be read (default setting)
• Read-only: In this mode, no video data is written onto the
data storage device. This setting is useful if you want to stop
data from being overwritten after an event.
• Redundancy: In this mode, video data will be redundantly
stored on all data storage devices with the "Redundancy"
setting. For this purpose, the “Redundancy” button in the
“Recording → Parameter → More Settings” menu must be
pressed.
• Group: For allocating the hard disk drive to an HDD group
Delete
Enable/disable hard disk drive