Under the Wi-Fi settings, you can select
the desired network to which the camera
should be connected.
When you select the menu item, all
networks in the vicinity are displayed.
Select your network and enter your in-
house Wi-Fi password.
Make sure that the signal strength is
sufficient to avoid transmission problems.
Enter the password and confirm with OK.
To prevent access by strangers, protect
your network by encrypting it with WPA/
WPA2/ WPA2-PSK.
The settings are not applied until you exit
the menu.
If the connection was not successful or
the wrong Wi-Fi information was entered,
press the reset button for 3 seconds to
set the camera to factory settings.
To Next Page
Loading...
