59
GROW LIGHT SYSTEM
DRIVER MOUNTING (FRAME): IONFRAME EVO
STEP 2
Flip the driver over and place it over the
two center columns of your grow light.
Secure the brackets to the columns by
screwing in the nylon screws using a
flathead screwdriver.
STEP 1
Align the brackets’ mounting holes with
the driver’s mounting points located on
the driver’s underside, making sure the
brackets’ legs are pointing up.
Secure the brackets by screwing in
the round head driver screws using a
Phillips screwdriver.
STEP 3
Connect the driver socket to the grow
light connector. This will lock the
connection in place.
Twist the lock and pull the connector out
to disconnect it from the driver's socket.
To Next Page
Loading...