10
QUICK BUILD GUIDE
1
Build the Grow Tent
(BOX A). Refer to the
CLOUDLAB section.
Install the Inline Fan with Straps (BOX
C), Ducting and Clamps (BOX G) to
your preferred configuration. Refer to the
CLOUDLINE section.
You may connect and
hang the Carbon Filter
with Straps (BOX F) to
your ductwork. Refer to the
Carbon Filter section. Use
Duct Tape (BOX I) to seal
any gaps in the ducting.
Clamp the Clip Fan
(BOX E) onto the tent
frame. Refer to the
CLOUDRAY section.
2
3 5
Hang the Grow Light using
Rope Hangers (BOX D)
by the roof support beams.
Refer to the Grow Light
section. Turn the knob to
“UIS” to pair and connect
with the controller.
4
To Next Page
Loading...
