72
CLOUDRAY
STEP 3
You may manage the cords using the
included cable ties or cable mounting set.
Adhere the tie mount onto a clean
surface. Loop the wire tie into the mount
and around the cables.
POWERING AND SETUP
STEP 1
Plug the fan’s power cord into an AC
power outlet to power the fan.
Plug the fan into the closest AC outlet to
allow for cable slack and avoid
cable tension.
STEP 2
Plug the UIS connector with the gasket
end into your clip fan. The gasket is
specially designed to protect against
liquids and dust.
Plug the standard UIS connector into one
of the controller’s ports.
To Next Page
Loading...
