61
DRIVER MOUNTING (WALL): IONFRAME EVO
STEP 4
If you are mounting onto anything other
than a wood support or stud, insert the
included four wall anchors into the drilled
mounting holes.
You may need to use a hammer to
secure them through the holes.
STEP 5
Align the bracket’s holes with the wall
anchors. Screw in four wood screws
with a screwdriver or drill to secure the
brackets.
STEP 6
Connect the driver socket to the grow light
connector using the driver extension cord.
Twist the lock and pull the connector to
disconnect it from the driver's socket.
GROW LIGHT SYSTEM
To Next Page
Loading...
